Brultech Greeneye Monitor Bedienungsanleitung PDF herunterladen (Seite 6)

GEM Setup Overview

 Page 5

GEM SETUP OVERVIEW

WEB INTERFACE PERFORMANCE

The performance of the setup interface is greatly improved by setting the GEM to “115200” baud.

The “baud rate” is the speed at which the GEM communicates with the browser. Early versions of the

GEM used “19,200” baud exclusively however newer versions of the firmware provides a means of

increasing the communication speed to “115,200”. The baud rate may be changed using the setup

interface or using the GEM Network Utility program.

Initial Entry

Opening the web interface may require clicking the browser’s address bar a couple of times with a long

pause in between. Once “Setup Mode” is entered, the performance will improve since the GEM will then

focus its resources on the interface.

Slow Page Load

The web interface is a bit slow at loading pages therefore wait until a page is fully loaded before clicking

another menu. If a page fails to load properly, simply wait a couple of seconds and refresh the browser.

Auto Refresh Pages

The “Watt” and “Watt-Hour” pages are automatically refreshed every eight seconds. When switching to

another menu from either one of these two menus, the page may not respond properly. Simply wait and

refresh the browser’s page and a proper display will eventually result.

Be Patient

Try to avoid clicking any page buttons several times. Sometimes there will be a couple of seconds delay

before the page loads.

Exit Setup Mode When Done

It is important to properly exit “Setup Mode” when done to allow the GEM to return to normal

operation.

BEHAVIOR

 When entering “Setup Mode”, the GEM stops sending packets or “keep-alive” characters

 Packet send will resume when “Setup Mode” is exited

 If web setup pages are inactive for 15 minutes, the GEM will automatically exit “Setup Mode”

and resume sending packets

 If “Watt” or “Watt-Hour” menu is selected and “Setup Mode” is not properly exited, the GEM

will not automatically exit this mode due to the auto-refresh nature of these two menu options.

Closing the browser will allow the GEM to exit “Setup Mode” after 15 minutes.

QUICK START

Quick start instructions are provided in the “Quick Start” chapter on page 39.

1 2 3 4 5 6 7 8 9 10 11 ... 42 43

Keine Kommentare

Brultech Greeneye Monitor Bedienungsanleitung Seite 6